| TMONEY |
|
Gold User, Member, Platinum User, TeleChart
|
| Registered User |
|
|
|
|
| Unsure |
|
| Tuesday, March 8, 2005 |
| Wednesday, February 1, 2012 3:36:53 PM |
49
[0.02% of all post / 0.01 posts per day] |
|
|
can i use my block built indicators and conditions from sf5.1 in tc2000v12
|
|
forgot to say i was told this was no longer supported in the program by support
|
|
this is the same problem i report a couple months ago. good luck, if you made it with blocks reconnect any line will work with a always for update
|
|
posted may 23 is anyone working on the real code vor my VA and VM 5 and 15min
|
|
i have send a layout to support and ask them to forward to Ask Trainer. my true marker no longer redraw so if you could please make rules in real code for me. they are VA and VM on both my 5min and 15min charts. i will try to learn real code so i can make my own from this point. Thank you for all the help. by makeing them as rules i will be able to filter by them. Tommie
|
|
ok have now tried the layout on a amd processor 6000+ at 3.02gh -64x2 duo core with 2gb ram and the vista operation system . the time run from 1min 20sec to 6 minutes. i was told that a mac was a lot faster. will try to find one to check out.
|
|
ok reloaded on main pc it run a little faster --recheck on all three units .it depends on whats going on in this program to the length ot time it takes to run a block built program . it run from40 sec to 5 minute and 20seconds to run the same program on the same pc. as far as memory goes it takes a little bit more time on 512mg than on 4g- 800meg herze memory. plan to try on a difference type processor (amd) as fast as i can. as i have stated before will buy processor and memory and hard drive just to run blocks if it will make it faster.this is a good program but way to slow to make it useable. blocks 2 was a much faster program.
|
|
do not have streaming input today but when put on my laptop it is a lot faster and the laptop on has 512meg memory. will complete remove from my main unit and do a clean blocks installation to see if it makes a difference
|
|
i will try on my two other computers as it may be in my setup. this is the tc version of total. ABS(C > MAXc32.1)*32+abs((V>(V1*6))AND(V>100)and(c>L1))*32+ABS(C > MAXc7.1)*32+ABS((V>(V1*2.5))AND(V>50)and(c>=l1))*32+(ABS((C>MAXC7.1)and(v<=avgv3.1)and(v<5))*32)*3+(abs((V > MAXV32.1)and(V > 50)and(c>=l1))*32)*2 i use this in a 5min and a 15min time frame i also use 2ndph192 on the left side in column area .
|
|
the layout are posted. passwords craig-mod and craig-working. they are the same just one the mod layout is stacked in one window. i use the working it is spread over three monitors.it takes 5 to 25 seconds to change between stocks and 2 to 5 minutes to sort . the lights are a little faster. thanks for any help that you can give.
|
|